Dark living room under a seamless stretch ceiling with a soft even glow

Gildspan · Tel Aviv-Yafo

The builder left a lid.


Stain in the corner, a bulkhead, a spotlight cut crooked. That lid is not a finished plane. We measure it, weld a membrane to the diagonals, and fit it across Tel Aviv-Yafo and Gush Dan.

MatteThe bay, when the builder’s lid should go quiet.
460 ₪Cove light, per linear metre, profile and tape. VAT included.
1 hourA single room on the visit. Several rooms take the morning.
340 ₪Matte, per square metre. Billed at not less than 8 m².

Six membranes.

01MatteThe quiet field. Living rooms, bedrooms, halls.340 ₪ / m² 02SatinA low sheen. Soft rooms that still want depth.360 ₪ / m² 03LacquerA dark mirror. Small rooms, dining, a hall.410 ₪ / m² 04AcousticA micro-perforated plane for a bedroom or a study.450 ₪ / m² 05StarFibre points, set by hand. One light engine in the void.760 ₪ / m² 06PrintedA photograph welded into the film, when the drawing asks.520 ₪ / m²

Guides for 2026, shekels per square metre, VAT at 18% included. Each room is billed at not less than 8 m², and a star room at not less than 10 m². An 18 m² matte room is 6,120 ₪, of which 933.56 ₪ is VAT.

01 · The lid

Read what the builder left.

A stained slab, a bulkhead, paint over a joint, a spotlight cut crooked. That lid is still a lid. Lacquer will show every bow in it. Matte will not. The membrane is decided from the slab, in the room, not from a photograph.

02 · The bay

Then the sheen.

Matte when the room should go quiet. Satin when window light should move and leave. Lacquer when the ceiling is asked to hold the lamp. Acoustic only if the void can take a lining. A star field only if the engine stays reachable. The film is cut at the bench.

03 · The line

Light is named last.

A cove at 460 ₪ a metre, rings for the spots already there, or fibres set by hand. A new electrical point belongs to a licensed electrician. We decide the opening. When the lid, the bay, and the line are named, the quote can be written. The cove is on Light.

The hour

The visit, in order.

One room is about an hour. The same six steps are written on the visit. Film is ordered only after the quote is approved.

01
Corners

Someone opens the door. The perimeter has to be reachable. A sofa can stay. A room stacked to the ceiling cannot.

02
Diagonals

Length, width, both diagonals. A wall out of square is cut as that wall, not as a rectangle on a drawing.

03
The drop

From the slab to the line of the profile, and what that line meets: plaster, tile, a curtain recess.

04
The void

Depth for a lining, a driver, or an engine someone can reach later. In a bathroom, the fan and the shower.

05
Openings

Spots, a detector, a diffuser, a sprinkler we do not move. The ring is ours. The circuit is the electrician’s.

06
The note

The quote is written from this hour. You approve it in writing. Until then, nothing is welded, and the hour itself was only a request.

A thin warm cove of light between a black ceiling and a dark wall

Light

A line, not a lampshade.

The plane can carry a perimeter cove, a spotlight opening, or a fibre field. New electrical points are a licensed electrician’s work. We cut and ring the membrane. We do not invent a permit the building does not need, and we do not skip one it does.

Light in the void

Installer seen from below on a low scaffold, face hidden behind the membrane

From the floor

The slot is a request until the desk confirms.

Send a visit note by WhatsApp. Sunday to Thursday we are at the bench from 08:00 to 17:00. Friday ends at 13:00. Saturday the workshop is closed.

Book a measure